Jump to content

Hommade caps?


Gresh

Recommended Posts

This forum is supported by the 12ozProphet Shop, so go buy a shirt and help support!
This forum is brought to you by the 12ozProphet Shop.
This forum is brought to you by the 12oz Shop.

ya, heres a little tutorial i made

OK if you cant find caps, or just lost em, heres an idea.

 

When your in a store most aerosol can caps are female(dont work with krylon etc). Heres how you can make them work with most cans.

 

>Materials needed<

1. Female cap

2. B.I.C pen ink tube

3. Knife(preferably a razor)

4. Lighter

 

 

>Directions<

 

1. Take your ink tube and blow the ink out of it(dont suck)

2. Cut a small 1 inch section off

3. Light one end and then stick it into the cap(make sure its secure)

4. Cut a rectangilar shape in the end of the ink tube(like the one on male caps)

5. Test, if it works spray away, if it dosent, try to apply less pressure when inserting into cap.

 

***PICS BELOW***

http://img.photobucket.com/albums/v479/gigatech/DSC02046.jpg

http://img.photobucket.com/albums/v479/gigatech/DSC02049.jpg

http://img.photobucket.com/albums/v479/gigatech/DSC02050.jpg

http://img.photobucket.com/albums/v479/gigatech/DSC02052.jpg

http://img.photobucket.com/albums/v479/gigatech/DSC02057.jpg

 

if you dont heat the ink tube enough it wont work, light it til its on fire and while its on fire stick it in the cap.

 

and the last pic, the tube shouldnt look like that, it should look nice and clean, but i want done cutting

 

 

 

 

 

 

 

 

If you dont understand say so and ill add more pics

Link to comment
Share on other sites

Guest
This topic is now closed to further replies.
×
×
  • Create New...