Jump to content

porkism

Member
  • Posts

    9
  • Joined

  • Last visited

Reputation

0 Neutral
  1. too lazy to see if this has been posted anywhere on this thread...i found a "how-to" for la caps or hex caps. 1= Get a regular cover off any krylon rusto etc. 2= you want the center part. Begin to cut off the excess plastic 3= Once you have center part by its self, its time to cut enough off to fit your finger in. i find using a bench grinder works fast. if you dont have access to a grinder, use an exacto. be carefull though the plastic cracks easy. 4= After you made the space for your finger, get a needle, thumb tack, pin etc. and heat it up with a lighter till it gets red hot. Then make a hole in the middle and move it around in a lil circle once or twice. Dont make the hole too high or too low ,if you do no paint will go through. 5= Put it ontop of the can to make sure it fits good, if you grinded (cut) too much from the center part the cap will fit too lose and not stay on. 6= When using the stencil/thin cap make sure to tilt the can upside down and flick the paint out, due to the small about of paint exiting the hole it will build up in the can and leak out and that will make a fucking mess and/or paint will spill onto your piece. get really fucking thin lines.
  2. a lot of my school sketches end up being on the back of my homework papers for some reason. have to scratch out the majority of them.
  3. if i'm not mistaken the textured krylon cans have caps that are the equivalent to a ny fat. i might be wrong. just go check.
  4. flare angles: just pop your wrist back for a flare.
  5. never used montana, don't intend on ever using it... all about american accents and all of the rusto brands.
  6. this is just like how everyone from around my way thinks that all writers are black.
×
×
  • Create New...