atari game cartridge mop.....
materials:
Atari Game Cartridge(duh)
flat and phillips head screw drivers or a knife
epoxy or silicon sealant
the ink of your choice
and the nub should be either part of a sock or felt.(foam doesn't cut it.)
this is simple.
1. find an atari game cartridge.
2. find the screw in the the middle and cut the sticker around it and unscrew.
3. with your knife or flat head screwdriver pry open the case. Be careful not to break the clips.
4. remove the chip and the spring. keep the movable plastic piece though.
5. on the edges of the cartridge, put on your sealant. Put back together.
6. Seal the outside cracks as well.
7. fill with your choice of ink.(this is not a refillable mop. but it will last you a long while.)
8. Smear your sealant on the inside of the bottom part.(this is where your sock/felt will go.) remember to hold the cartridge upright or else your ink will pour out.
9. jam the sock or felt into the opening and get it stuffed in there good.
10. let dry for a few minutes while placing it upright on your workspace.
11. go paint.
the cap can be just about anything. mine is a piece of folded cardboard wrapped in duct tape.
and just in case you don't want any leaks if you didn't seal it right, wrap that ho in duct tape and you'll be fine.
there you go. have fun.
